| 塑料注射成型过程中运动前锋面后的非定常边界层 |
| 陈允明 ; 沈申甫
|
Source Publication | 中国科学A辑
|
| 1987
|
Issue | 3Pages:280-285 |
ISSN | 1006-9232
|
Abstract | 由于溶融塑料的粘性大而导热性能差,因而,它在注塑机的型腔中流动时在壁上形成薄的温度边界层.本文考虑了粘性耗散,求出了从流动前锋面直到型腔入口处的完整相似性解.然后分析了这种有两个“等效前缘”的边界层的特性和相应的解法,并讨论了温度分布的特点.本文结果对注塑机的型腔设计和自动控制程序设计都有一定的意义. |
Keyword | 热边界层
非定常边界层
粘性系数
相似性解
边界条件
粘性耗散
Taylor
基本方程
塑料注射成型
|
Language | 中文
|
Document Type | 期刊论文
|
Identifier | http://dspace.imech.ac.cn/handle/311007/36954
|
Collection | 力学所知识产出(1956-2008)
|
Corresponding Author | 陈允明 |
Recommended Citation GB/T 7714 |
陈允明,沈申甫. 塑料注射成型过程中运动前锋面后的非定常边界层[J]. 中国科学A辑,1987,3,:280-285.
|
APA |
陈允明,&沈申甫.(1987).塑料注射成型过程中运动前锋面后的非定常边界层.中国科学A辑(3),280-285.
|
MLA |
陈允明,et al."塑料注射成型过程中运动前锋面后的非定常边界层".中国科学A辑 .3(1987):280-285.
|
File name:
|
Paper0688.pdf
|
Format:
|
Adobe PDF
|
This file does not support browsing at this time
Items in the repository are protected by copyright, with all rights reserved, unless otherwise indicated.
Edit Comment